Sample Wiring

All systems supply electrical feedthroughs for user connections into the sample space.

wiring harnesses

Simple low conduction cable harnesses are available with 2, 3, 4 or 5 pins. These generally have a straight section for thermal lagging and a coiled section for thermal heat dissipation. Options include:

P/N Wire Type Length One End Other End Use
4100-364-xx Phosphor Bronze xx Inches 2 pins on 2mm spacing 2 pins on 2mm spacing Attocube open loop stages
4100-365-xx Phosphor Bronze xx Inches 5 pins on 2mm spacing 5 pins on 2mm spacing External cable from Attocube harness to Montana Instruments external connector
4100-625-xx Phosphor Bronze xx Inches 5 pins on 2mm spacing 5 sockets on 2mm spacing Attocube closed loop stages or CB12 or DIP16 electrical sample mounts
  Phosphor Bronze xx Inches 5 pins on 2mm spacing 5 pins on 1.6mm spacing MO14 electrical sample mount
4100-1138 1GHz coax 4" SMP SMP From semirigid coax to user device on piezos

 

Below are examples of typical low frequency wiring harnesses, with a straight section to run under the thermal lagging location and a coiled section for thermal heat dissipation inside the radiation shield. 

Flexible Circuit connectors

New 12 and 25 pin flexible circuit connector options provide superior thermal anchoring and keep the wiring clean and organized. These flexible circuits come standard on the Fusion, and are also used in various other options, such as the R2D12 electrical sample mount and platform heaters.